Amped Plumbing Blog · Plumbing Tips
Low Water Pressure in Your House: Causes and Fixes
Step 1: one fixture, hot only, or the whole house?
- One faucet or shower: the problem is at that fixture.
- Hot water only, everywhere: the problem is at the water heater.
- Hot and cold, everywhere: the problem is on the main supply.
- Sudden, and the neighbors have it too: call the water utility.
One fixture
- Faucet: unscrew the aerator at the tip and rinse out the grit and scale.
- Shower: clean or replace the showerhead. Hard water scale blocks the holes.
- Check the shutoff under the sink or behind the toilet. It may be partly closed.
- If that does not fix it, the cartridge or valve inside the fixture is worn or clogged.

Hot water only
- The valve on the cold line above the water heater is partly closed.
- Sediment has built up in the tank and lines. A flush is part of a water heater tune-up.
- An old heater or its connections are scaled up; see water heater repair or replacement.
The whole house
- A main valve not fully open, at the house or at the meter, often after recent work. Where to find your main shutoff.
- A failing pressure regulator. Homes that have one can lose pressure, or get too much, when it wears out.
- A leak. Water escaping from a line under the slab or in the yard lowers pressure everywhere. Check the meter with everything off: how to check for a hidden water leak.
- Old galvanized pipes. They rust and scale shut from the inside over decades. Pressure fades slowly, and is worst when two fixtures run at once.
- Scale from hard water in pipes, valves and fixtures; see does Oklahoma City have hard water.
Sudden or gradual?
Sudden: think valve, regulator, leak or the utility. Gradual over years: think pipes closing up with rust or scale. That difference narrows it down quickly.
When it is the pipes
If the home still has galvanized steel water lines and pressure has been dropping for years, cleaning fixtures will not bring it back. The lasting fix is new piping. Pipe repair vs. whole-house repiping explains when each makes sense, and 5 signs of damaged water pipes lists what else to watch for.
What a plumber checks
- Pressure at an outside faucet with a gauge, with water off and with water running.
- The regulator and main valves.
- The meter, for a hidden leak.
- The type and condition of the piping.
Amped Plumbing can test the system, check for a hidden leak and tell you what it will take to fix.
Common questions
Why is my water pressure suddenly low?
A partly closed valve, a failing pressure regulator, a leak, or a problem on the water utility side are the usual causes of a sudden drop.
Why is the water pressure low in only one faucet?
The aerator is clogged with grit or scale, the shutoff under it is partly closed, or the faucet cartridge is worn.
Can a leak cause low water pressure?
Yes. A leak in the main water line, under the slab or in the yard lets water escape before it reaches the fixtures and lowers pressure through the house.
Amped Plumbing is a licensed plumbing company (OK Plumbing Contractor License #049194, held by Mickey Lyons) based in Warr Acres and serving the Oklahoma City metro, including Edmond, Moore, Yukon, Norman, Bethany and Nichols Hills.