Call Us Anytime

Amped Plumbing Blog · Water Leak Detection

How Plumbers Find Hidden Water Leaks

By Joe Norton, Owner, Amped Plumbing · Warr Acres, OK · OK Plumbing Contractor Lic #049194
Reviewed by Mickey Lyons, licensed plumbing contractor
Updated November 17, 2026

Short answer: Plumbers find hidden leaks in three stages: confirm there is a leak with the water meter and a pressure test, isolate which line it is on by shutting valves, then pinpoint the spot with acoustic listening equipment or tracer gas. Done properly, only a small area at the leak itself has to be opened.

Stage 1: confirm it

With all water off, a moving water meter proves water is escaping. A pressure gauge on the system confirms it: if pressure drops with every tap closed, a line is leaking. You can do the meter part yourself; see how to check for a hidden water leak.

Stage 2: isolate it

  • Shutting the valve at the water heater shows whether the leak is on the hot or cold side.
  • Shutting off the sprinkler system rules the yard in or out.
  • Toilets and fixtures are checked one by one.
  • On homes with a manifold, each line can be shut off separately.

This narrows a whole house down to one line.

Amped Plumbing tech using a light to inspect for a leak

Stage 3: pinpoint it

Acoustic listening. Water escaping a pressurized pipe makes a sound. Sensitive ground microphones and headphones let a technician hear it through concrete and follow it to its loudest point.

Tracer gas. When a leak is too small or too deep to hear, the line is filled with a safe tracer gas. The gas escapes at the leak and rises through the slab or soil, where a detector picks it up.

Amped Plumbing uses both methods; see water leak detection.

What these methods do not cover

Leak detection is for pressurized water lines. Problems inside drain and sewer pipes are found with a camera instead; see what a sewer camera inspection shows.

What happens after it is found

You get the location and the repair options. For a leak in a wall, that is usually a small opening and a section of new pipe. For a leak under the slab, the choices are a spot repair, a reroute or a repipe; slab leak causes and repair options compares them.

Tips before the plumber arrives

  • Note which signs you have seen and where.
  • Write down the meter reading and time.
  • Keep the house quiet during the visit; acoustic equipment needs it.
  • Clear access to the water heater, the meter and under sinks.
Need a leak found?

Amped Plumbing pinpoints hidden leaks with acoustic and tracer-gas equipment across the Oklahoma City metro.

Common questions

How do plumbers detect a leak under a slab?

With acoustic listening equipment that hears water escaping through the concrete, and with tracer gas for leaks too quiet to hear.

How accurate is professional leak detection?

It usually narrows the leak to a small area, so only that spot has to be opened instead of exploring with a jackhammer.

How long does leak detection take?

Often one to two hours for a single leak, longer if the house has several or the line is hard to isolate.

About the author: Joe Norton is the owner of Amped Plumbing. He started the business in 2008, working out of a single truck, and built it on hard work and word of mouth. More about Amped Plumbing.

Amped Plumbing is a licensed plumbing company (OK Plumbing Contractor License #049194, held by Mickey Lyons) based in Warr Acres and serving the Oklahoma City metro, including Edmond, Moore, Yukon, Norman, Bethany and Nichols Hills.

Need cameras or an alarm system? Visit Amped Security →