Amped Plumbing Blog · Emergency Plumbing
What to Do When a Pipe Bursts in Your Home
Step 1: shut off the water
Go to the main water shutoff and close it. In most Oklahoma homes it is where the water line enters the house: in the garage, a utility closet, near the water heater, or at a plumbing manifold. A valve under a sink only controls that sink.
If you cannot find the house shutoff, there is usually a shutoff at the water meter near the street. Use it only if you can clearly identify it and your utility allows it. If you are unsure, call your water utility for an emergency shutoff.
Step 2: make it safe
- Turn off the power at the breaker panel for any room with standing water or water running down walls or through the ceiling. Do it only if you can reach the panel without standing in water.
- Stay out of standing water near outlets, appliances and cords.
- If the ceiling is sagging with water, keep everyone out from under it.

Step 3: drain the lines and contain the water
- Open the cold taps, starting with the lowest one in the house, to drain what is left in the pipes.
- Turn the water heater off, then open hot taps to drain those lines.
- Put buckets under drips, and move rugs, furniture, boxes and electronics out of the wet area.
- Mop or wet-vac standing water and run fans. The faster it dries, the less damage.
Step 4: document it, then call
Take photos and video of the burst pipe and everything that got wet before you clean up. Your insurance company will want them.
Then call a plumber. Tell them where the water was coming from and that the main is off. A temporary clamp or tape may slow a leak, but it is not a repair, and the water should stay off until the pipe is fixed.
Why pipes burst
- Freezing. The most common cause in Oklahoma winters. See emergency plumbing for what to do in a freeze.
- Age and corrosion. Old galvanized and copper lines thin out and fail.
- High water pressure that strains pipes and fittings.
- Shifting soil that stresses lines under a slab.
If lines are failing in more than one place, patching each leak costs more over time than repiping the house. If the burst was hidden and you are not sure it was the only one, water leak detection finds the rest.
Shut the main off and call. Tell us where the water is coming from and whether it has stopped.
Common questions
Where is my main water shutoff valve?
Usually where the water line enters the house: the garage, a utility or water heater closet, or a plumbing manifold. Some homes only have a shutoff at the meter box near the street.
Is a burst pipe covered by homeowners insurance?
Many policies cover sudden, accidental water damage, but coverage varies. Take photos before cleanup and call your insurance company to find out what your policy covers.
Can I turn the water back on after a temporary patch?
Not until the pipe is properly repaired. A clamp or tape can fail under pressure. Leave the main off, or have a plumber isolate that line so the rest of the house has water.
Amped Plumbing is a licensed plumbing company (OK Plumbing Contractor License #049194, held by Mickey Lyons) based in Warr Acres and serving the Oklahoma City metro, including Edmond, Moore, Yukon, Norman, Bethany and Nichols Hills.